Artikel CC BY 4.0
referiert
Veröffentlicht

Sorption von Phosphorwasserstoff sowie eines Gemisches von Phosphorwasserstoff + Methylbromid durch Expeller und Extraktionsschrote

Zugehörigkeit
Biologische Bundesanstalt für Land- und Forstwirtschaft, Institut für Vorratsschutz, Berlin-Dahlem
El-Lakwah, Faris

Versuche über das Sorptionsverhalten verschiedener Expeller und Extraktionsschrote gegenüber PH3 ergaben bei 20 °C bei einer Ausgangskonzentration von ca. 800 ppm nach einer Sorptionsdauer bis zu 72 Stunden Sorptionswerte bis zu 62 % der Ausgangskonzentration (1 kg Sonnenblumenexpeller-Pellets). Der Vermahlungsgrad der Ware zeigte dabei keinen deutlichen Einfluß auf die Sorptionswerte; jedoch war die Sorption abhängig von der Höhe der Ausgangskonzentration. So wurde beispielsweise mit niedriger PH3-Konzentration (30 ppm) ein Sorptionswert von ca. 85%, mit hoher Konzentration (1600 ppm) dagegen nur ein Sorptionswert von 35% der Ausgangskonzentration gefunden. Die Abhängigkeit der Sorption von der vorgelegten Warenmenge im Begasungsraum wurde untersucht, wobei festgestellt werden konnte, daß der Sorptionsfaktor mit zunehmender Warenmenge steigt, wie es auch bei der CH3 Br-Sorption der Fall ist. Kombinationsbegasungen mit PH3 + CH3Br ergaben, daß die Sorptionswerte der beiden Gase im Gemisch praktisch genau so hoch sind wie die bei Einzelbegasungen ermittelten Werte, vorausgesetzt daß die Versuchsbedingungen identisch sind.

Sorption of phosphine (PH3) as weil as a mixture of phosphine + methyl bromide (CH3Br) by expeller and extracted by-products of oilseeds. Investigations conducted in the laboratory about the sorption of PH3 by various expellers and extracted by-products of oil-seeds at 20 °C with an average initial concentration of 800 ppm and a sorption time up to 72 hours showed that the sorption rate obtained for 1 kg pelleted sunflower-expeller was about 62% of the initial concentration. The sorption rate of PH3 was independent on the fineness of the product, but dependent on the height of the initial concentration; for example at low PH3 concentration (30 ppm) the sorption rate obtained was about 85%, at higher concentration (1600 ppm) however only 35 % of the initial concentration. The relation between the volume of the enclosure and the weight of the commodity being fumigated has shown a pronounced effect on the sorption rate of PH3 by the commodity whereby the sorption rate was increased with a rise in the load-ratio, this trend was also found for the sorption of CH3Br. Tests carried out to determine the sorption rate of PH3 as well as CH3Br from mixtures of different concentrations showed that, in case the experimental conditions were the same, the sorption rate of the two gases in a combined fumigation was similar to the sorption rate obtained by the commodity with PH3 as well as CH3Br alone.

Vorschau

Zitieren

Zitierform:
Zitierform konnte nicht geladen werden.

Zugriffsstatistik

Gesamt:
Volltextzugriffe:
Metadatenansicht:
12 Monate:
Volltextzugriffe:
Metadatenansicht:

Rechte

Nutzung und Vervielfältigung: